Potentiometer Mounting 4

The new supports were printed out and the seem to work well enough, but I think for the final product I will end up hot-gluing it together. To keep the last pot in place I made a new support the was just the ring and the clamp part, but I accidentally made it with the ring and the peg part that inserts into the other pots. I fixed this and printed them out again and the seem to work as well. You can see in this picture the new parts which all have rings on them: And here it is on my hand:

Here are the new parts that I printed, they are the green piece and the part to the right of it:

In this video you can see it moving, you can also see the one on the ring finger is broken already. I’ll probably put some hot glue on that and call it good enough. Glove controller with new supports