I printed out the rings to go on the ends of the fingers but they didn’t fit all of my fingers so a few had to be enlarged. I accidentally broke two of them while doing this, so only my first and middle finger could be hooked up. I also started printing out the new main mounts which have rings in them as well, but those won’t be done for a while. To attach the controller to my hand I just used electrical tape for now. IMG_5186 IMG_3934


Here is a short video of it working with the Unity program: Glove Controller working with Unity


Here is one of the new supports with the ring in it. It is a little bit loose, so I made some changes to the model and will print it out tomorrow. The print says it will take 18 hours so I’ll have to wait until Friday to see if they fit properly. IMG_0565 IMG_0564